OKI MICROLINE 590 DRIVERS

Be sure to test the printer after replacing each part. Lift and remove the gear case assembly. Detach the interface cable, if installed. Determine the preference of the end user regarding this feature. Use a straight-slot screwdriver to release the four claws 1 of the gear case assembly 2. This manual also for:

Uploader: Kazitaxe
Date Added: 28 December 2016
File Size: 56.34 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 54768
Price: Free* [*Free Regsitration Required]

Main RSPL 3. Rolling Ascii Test At the top of the test is the printer type oki microline 590emulation 2country 3and firmware revision level 4. Remove the paper, if installed 2.

Oki Microline Printer Ribbon Cartridge and Printer Supplies at

Has the ribbon been installed properly? Small pieces of paper can cause paper jams. Set the change lever 2 to the bottom feed oki microline 590 toward the rear of the printer. Move the carriage assembly.

Check the tension of all the front pressure rollers to see if they are the same. After that, you must oki microline 590 the platen knob, and then push the change lever down. This auto-gapping process leads to longer printhead life. Use a straight slot screwdriver to release the claws and remove the cable microljne oki microline 590. Got it, continue to print.

Related Drivers:  SCR338 USB KEYBOARD SMART CARD READER DRIVER

The printer has the following cable requirements.

Control Board to Printhead Interconnect Diagram: Paper Detection Mechanism 2. Page Contact between Bias Gear mciroline 3. The unit may not be plugged in.

Approximately 4 million characters Color: Continuous paper is fed by these two tractors at the same oki microline 590. Using The Raps 4. Does the paper being used meet the specifications for this product?

Be sure to secure the printhead so it will not move during shipment. This will disengage the adjust gear from idle oki microline 590 D. Make sure that the paper you are using is within specifications.

OKIDATA Microline 590 User Manual

oki microline 590 Page Gear: Next, you must remove the paper from the tray, and then detach the interface cable. Stand and Metal Tear B Paper Feed Methods 1. It is an automatic procedure. An oki microline 590, user-installable Color Kit coupled with a customer-provided color software package allows. Printing will resume when the printhead temperature drops below degrees Celsius.

Related Drivers:  ACER ASPIRE M5641 COPROCESSOR DRIVER

Comments to this Manuals Your Name. Ribbon is “dried out”. Make sure the carriage cable is properly connected to the space motor assembly and CN7 on the main control board. Change the interface cable.

Remove any printed pages from the printer.