We look at the increase in stability due to the far corners [extreme heel or toe] of a square design and implement a new design that has the effect of square geometry. Higher lofts also have a shallower face height, a more closed face angle and more upright lie angle to help you square the face at impact. The former college golfer, now 34, has an ability to consistently contact drives in the center of the club face. Tom Stites, Director of product creation: With my swing speed and ball speed staying about the same, I added an average of 7. On a simulator and launch monitor I found it to be longer than the R9 and preferred the feel and ball flight better, which might be attributable to the shaft. Rick Wahlin, product engineering manager, Nike Golf:

Uploader: Metaxe
Date Added: 24 October 2014
File Size: 36.48 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 6489
Price: Free* [*Free Regsitration Required]

In Their Own Words: Nike say this can crate a maximum of 42 yards difference between the two widest tracjectories.

All skill levels Tom Stites, Director of product creation: The center of gravity CG and face angle vary by loft to optimize launch and spin. This is what keeps the golf industry nike sq dymo str8 biz! It was the longest and straightest driver I hit in the test.

Nike SQ Dymo STR8-FIT Driver

I saw an average of a 1. The result was a smaller average distance gain with his new TaylorMade, but still nike sq dymo str8 impressive one. Did he want to continue to chase more distance or did he want a driver that would help him hit more fairways?

Related Drivers:  DATACARD SP55 DRIVER

With my swing speed and ball speed staying about the same, I added an average of 7. For starters, the tsr8 “PowerBow” gets thicker as loft increases from 8.

This shifts more mass farther back and to the heel side for added draw bias. In my book there are 3 settings of merit. All Dymos have wtr8 pockets in the rear toe and heel areas for added forgiveness.

I was a bit anxious to see if it would hold up as dyo right fit, but after just nike sq dymo str8 couple swings on the range at Aviara, I was convinced! Sign Up For Newsletters Receive insider analysis, swing tips, equipment news, special offers and much more. For that reason, I felt more confident with the G drivers in my hands. Eddie Pepperell is never dull.

Nike SQ Dymo STR8-Fit Driver Review – Golfalot

Redditor Tijuanas posted the broken tee featured above. Where the normal Dymo is fairly quiet this one is much more raucous and sounds how it feels; supremely hot. The M2 D-Type gave Andrew the confidence to play his preferred cut ni,e off the tee without fear that it would drift into the right rough.

Without even considering nike sq dymo str8 adjustability, the STR8-FIT takes all these facets of performance and gives them a healthy boost. And the higher nike sq dymo str8 will hike at least one setting that will work well. For that reason, he switched Nike sq dymo str8 from dy,o 8. Some have said that golfers should learn to hit the ball properly and not rely on clubs to cure a hook or a slice. He fits into a group of golfers who are often hard pressed to see distance gains from new clubs.


He arrived at his fitting with a Ping G TaylorMade M1 9.

Even at a higher loft, nike sq dymo str8 was able to reduce his spin rate an average s rpm. Like a diesel engine, George needed some time to warm up during his fitting. Write a Review Rate This Product: The really good golfers might have 3 or 4 settings, depending on the course which is like having a tour van adjust your driver.

Sign Up for Newsletters Receive insider analysis, swing tips, equipment news, special offers and much more. That made the choice obvious; he was going to target consistency.

Nike SQ Dymo Squared and Dymo Squared STR-8 Fit drivers

The two changes had George hitting high-launching, low-spinning bombs that barely had any curvature. The innovative “Str8-Fit” adjustable fitting system features a specially designed shaft adapter and hosel that tilt 2 degrees off axis. Published 1 year ago on Mar 22,